FAQ

Normally it is around15~60 working days but depends on different product. We will let you know when you place the order.

The color of product is able to be chosen. We have provided orange, white, blue and red. If they're not reach your requirement, the color you asked is acceptable but we will charge the extra fee for it.

Yes, some of the product is equipped with fuse valve which can prevent the unpredictable dropping of lift table. If you have further concern, we also provide Accordion attached which can wrap the scissor structure.

Yes, we recommend that you use the R-32 engine oil. The following is replacement step:

1. Rising the table before pulling safety plate out and lay it down.
2. After laying safety plate down, against the table base then it can start to be repaired. (Note: if it isn't necessary, please don't operate it when it is loading.)
3. Loose the oil tube and leak the oil.
4. Please remember to clear oil inside it until hearing the "pu-pu-pu" sound.
5. Lock the tube tightly
6. Switch on the knob and level rod is inside.
7. Fill oil in the oil box.
8. Put level rod into it and take a measure. It just be half covered by oil.

If there is any question, please contact us.

Oil seal might be wear and oil is usually leaked if it used for a while so oil seal have to be replaced.
It is difficult to judge saying how long need to be changed. It depends on your use frequency.
Some customer change the oil seal after ten years usage. Basically, we offer one year free warranty if product is used under normal situation. You don't worry about it.

If there is no oil leakage, you don't need to supply extra oil. If you would like to keep product in good condition, you can use the air gun blow off the dust in case the dust impair the quality.

The following is description of voltage and battery:

• There are only two voltage can be selected for Battery Powered Lift Table. There are 110V/single-phase, 220V/3 phase, 220V/single-phase, 380V/3 phase can be selected for Table.
• About battery, we don't recommend you are using the product during battery charging. We also don't recommend you charge it until ran out of power, just like cellphone. It is not good for machine if it is completely no power.
  There are three color of light on the machine. (red, yellow, green)
  Green: Power is more than 80~90%.
  Yellow: Power is more than 40~50%.
  Red: Power is only 20~30%. You need to charge it soon.

There are two type of limit switches:

• Continuous limit switch (one touch): Press the button it will rise up to the height which limit switch set up.
• Discontinuous limit switch (jog): Before reaching the pre-set height, it can be stop at any height you request. It also can be stopped at pre-set height accurately.